mic overheads in a challenging environment
just recorded (wait for it) a childrens storytime at st kilda library. we're moving towards podcasting them, along heaps of other council content. all to end up as MP3, so tracked just as 16/44.1.
had to deal with a room full of 2year olds and their parents crashing and thumping around.
but that wasn't the worst of it - damn industrial strength air conditioning blasting through the entire area - no-where i could find that was out of the air flow. was an exercise in harm minimisation.
brought in a couple of different options -
the large diaphragm condensor (tried fig 8 omni and cardiod patterns) - boomed like a fighter jet on afterburn. even with popshield AND foam windscreen AND low cut.
fixed stereo back-electret - although the pickup was oriented to exclude the air blast, the diaphragm warbled and crashed. tried low cut from 160hz but low-end energy was too massive.
rode NT5 small diaphragm condensors - haven't played with these for YONKS. with foam windshields on, low-cut at 100hz, and pop shield b/w the rear of the mics and the air-con outflow, seems clean enough to use.
next week, might try a crown PZM, but not sure it'll be an improvement . . .
just thought you might like to know . . .
chris.
had to deal with a room full of 2year olds and their parents crashing and thumping around.
but that wasn't the worst of it - damn industrial strength air conditioning blasting through the entire area - no-where i could find that was out of the air flow. was an exercise in harm minimisation.
brought in a couple of different options -
the large diaphragm condensor (tried fig 8 omni and cardiod patterns) - boomed like a fighter jet on afterburn. even with popshield AND foam windscreen AND low cut.
fixed stereo back-electret - although the pickup was oriented to exclude the air blast, the diaphragm warbled and crashed. tried low cut from 160hz but low-end energy was too massive.
rode NT5 small diaphragm condensors - haven't played with these for YONKS. with foam windshields on, low-cut at 100hz, and pop shield b/w the rear of the mics and the air-con outflow, seems clean enough to use.
next week, might try a crown PZM, but not sure it'll be an improvement . . .
just thought you might like to know . . .
chris.